East Coast Solar
Solar Energy Products
D5-VARIO Laing D5 VARIO Bronze PV-Direct Circulating Pump
Laing D5 variable speed Bronze PV-Direct Circulating Pump.
The first DC spherical motor pump for direct connection to photovoltaic panels with automatic performance optimization using MPPT technology (Maximum Power Point Tracking)
The principle of the spherical motor, which was invented by Laing, is fundamentally different from conventional canned motor pumps. The only moving part in a spherical motor is a hemispherical rotor/impeller unit, which sits on an ultra-hard, wear-resistant ceramic ball. There are no conventional shaft bearings or seals. This rules out, in effect, the possibility of play in the bearings and the increase in noise associated with it. These pumps are particularly robust and give exceptionally long service. The self-realigning bearing is lubricated and cooled by the media. Maintenance is not necessary under normal conditions and even after lengthy shutdown periods a reliable start-up is virtually guaranteed. The parts exposed to the fluid are completely corrosion resistant.
The pump has been programmed for a soft start-up. When the photovoltaic panel provides sufficient power, the pump first goes through the alignment phase, turning the rotor into the position required for start-up. Then the processor waits until the built-in capacitor has recharged sufficiently. This enables a start-up with minimal power (less than one Watt!). Cycling due to unsuccessful starting attempts is minimized.
Automatic performance optimization
– MPP tracking The Ecocirc DC pumps are the first and only spherical motor pumps with self-optimizing software (see diagram). Every three seconds, the processor will modify its operating point on the voltage-current curve of the PV panel to find the point of maximum performance. This is called the “Maximum Power Point” (MPP).
List price $409.00 ~ You save $119.05
Model D5-38 Options
Terms & Conditions
Your IP Address is 126.96.36.199